Interesting article - 15 Ways Successful People Approach Life Differently

Interesting article – 15 Ways Successful People Approach Life Differently

Found this interesting: 15 Ways Successful People Approach Life Differently  

Read Article →
Week 18 - Binding Strips & Fret Board

Week 18 – Binding Strips & Fret Board

Binding Strips Removed masking tape holding b/w/b decoration strips Use flat file to remove excess glue round the binding channel Remove bindings from side-bender and…

Read Article →
Week 17 - Decoration strips

Week 17 – Decoration strips

Took bindings out of side bender – checked how they looked against body and decided a black/white/black strip was needed to break up the colouring….

Read Article →
Week 16 - Body

Week 16 – Body

Removed body from mould. As for back, used edge trimmer to take off exess. Cutting channel for bracing Put cutting tool into side bracing jig…

Read Article →
Week 15 - Top fitting

Week 15 – Top fitting

Top fitting Finish fitting top to sides Cut kerfing so braces fit flush town & top doesn’t rock Glue round top of kerfing & fit…

Read Article →
Week 14 - Sound board and neck

Week 14 – Sound board and neck

Sound board Cut side braces 9mm wide from leftover spruce from top (using band saw) Cut to length to fit between kerfing at waist and…

Read Article →
Week 13 - More body work

Week 13 – More body work

More body work Use edge trimmer in router to take excess of back while in mould. Trim to match the side Check rotation direction of…

Read Article →
Week 12 - Fitting the back

Week 12 – Fitting the back

Back fitting Align back on sides so that centre lines up and in position Taped back to sides with masking tape Mark brace positions on…

Read Article →
Week 11 - Back kerfing

Week 11 – Back kerfing

Back preparation Removed sides from mould (had to use big chisel to get sides out of mould) Put blocks and dowels into holes in mould…

Read Article →